© 2020 by FRED LLC

Keypad Instructions

Programming The Keypad

Programming Interface:

All codes are four (4) digits in length.  Entry code is a four (4) digit code needed to activate the gate.  Master Code is needed to add, remove or reset entry codes.  Master Code also functions as the entry code under normal operation.  Factory default Master Code is 1234.  STATUS light should blink and beeper should beep (once) whenever any button is pressed.  If more than 10 seconds elapsed between key presses the unit returns to normal (idle) operating mode.  Keypad can only enter program mode from sleep mode (keypad is turned OFF).  Keypad will beep three times before going into sleep mode.

 

Program New Master Code:

Press and release PROGRAM button.  Enter the old Master Code then press and release PROGRAM button.  Enter 0, 6 then press and release PROGRAM button.  Enter the new Master Code then press and release PROGRAM button.  Enter the new Master Code then press and release PROGRAM button again for confirmation.  Beeper beeps 3 times to confirm that the new Master Code is accepted.

 

NOTE: If the Master Code is not a matched pair or error occurs (i.e. if the entry code is NOT a 4-digit code) the STATUS light will flash rapidly and the beeper will sound for 2 seconds before returning to normal operation with old Master Code.

 

Program (Add) New Entry Code:

Press and release PROGRAM button.  Enter the Master Code then press and release PROGRAM button.  Enter 0, 2 then press and release PROGRAM button. NOTE: If memory is full (all 25 locations are already programmed) the STATUS light will flash rapidly and the beeper will sound for 2 seconds before returning to normal operation, without saving.  Enter the new Entry Code then press and release PROGRAM button.  Beeper beeps 3 times to confirm that the new Entry Code is accepted.

 

NOTE: If the code is NOT 4-digits in length or an error condition has occurred, the STATUS light will flash rapidly and the beeper will sound for 2 seconds before returning to normal operation, without saving.

 

Delete An Entry Code:

Press and release PROGRAM button.  Enter the Master Code then press and release PROGRAM button.  Enter 0, 3 then press and release PROGRAM button.  Enter the Entry Code to be deleted then press and release PROGRAM button.  Beeper beeps 3 times to confirm that the new Entry Code is deleted.

 

NOTE: If no matching code is found or the code is NOT 4-digit in length then an error condition has occurred, the STATUS light will flash rapidly and the beeper will sound for 2 seconds before returning to normal operation, without saving.

 

Program (Add) New Temporary Entry Code:

Press and release PROGRAM button.  Enter the Master Code then press and release PROGRAM button.  Enter 8, and any number between 1 thru 7 then press and release the PROGRAM button. The second number indicates the number of days after which the code will be automatically removed from memory.

 

NOTE: If memory is full (all 25 locations are already programmed) or an invalid entry is detected then an error condition has occurred, the STATUS light will flash rapidly and the beeper will sound for 2 seconds before returning to normal operation, without saving.  Enter the new Entry Code then press and release PROGRAM button.  Beeper beeps 3 times to confirm that the new Entry Code is accepted.

 

NOTE: If the code is NOT 4-digit in length or an error condition has occurred, the STATUS light will flash rapidly and the beeper will sound for 2 seconds before returning to normal operation, without saving.

 

Low Battery Indication Summary:

 

Low Battery Indicator:  Beeps twice when any key is pressed.

Battery OK:  Beeps once when any key is pressed.